10. If you removed the fan cage assembly, install it. (See “Replacing the fan cage
assembly” on page 173).
11. Insert the hard disk drives and the fillers the rest of the way into the bays.
Updating the server configuration
Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
If you have installed a USB hypervisor memory key on the SAS riser-card, see the
user's guide that comes with the hypervisor memory key. Hypervisor enables guest
operating systems to function on the server.
For information about configuring the integrated Gigabit Ethernet controller, see
“Configuring the Ethernet controller” on page 61.
SAS signal cable
(Y cable)
Power / configuration
cables
SAS 0
SAS 1
Figure 264. Cable connections
302 System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
Need help?
General