Removing the media cage
Use this information to remove the media cage.
About this task
To remove the media cage, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. Remove the top cover (see “Removing the top cover” on page 146).
4. Disconnect the front USB, DVD drive and operator information panel/LCD
panel cables from the system board. Please remember the relevant cable
routing.
Note: To disconnect the operator information/LCD panel cable, press evenly
on the connector first; then, pull the cable out.
Operator information /
LCD panel cable
DVD drive cable
Front USB cable
Figure 100. Cable routing
176 System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
