IBM System x3650 M5 - Replacing an Adapter

Replacing an adapter
Use this information to replace an adapter.
Replacing an adapter in a riser-card assembly:
Use this section to replace an adapter in a riser-card assembly.
About this task
The following illustration shows the locations of the adapter expansion slots from
the rear of the server.
The following table describes the maximal card dimension supported in each slot.
Table 13. The maximal card dimension supported in each slot
Riser-card assembly
Slot
number The maximal card dimension supported
Riser-card assembly 1 1 Full height, up to full length
2 Full height, up to full length
3 Full height, half length
4 Low-profile
5 Low-profile
Slot 1
Slot 2
Slot 3
Slot 6
Slot 7
Slot 8
Slot 4 Slot 5
Figure 119. PCI riser-card adapter expansion slot locations
Slot 1
Slot 2
Slot 3
Slot 4 Slot 5
3.5-inch rear two
hard-disk-drive kit
Figure 120. PCI riser-card adapter expansion slot locations
Slot 4 Slot 5
3.5-inch rear two
hard-disk-drive kit
Slot 3
2.5-inch rear two
hard-disk-drive kit
Figure 121. PCI riser-card adapter expansion slot locations
190 System x3650 M5 Type 5462: Installation and Service Guide