CAUTION:
When laser products (such as CD-ROMs, optical drives, fiber optic devices,
or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
Class 1 Laser Product
Laser Klasse 1
Laser Klass 1
Luokan 1 Laserlaite
Appareil A Laser de Classe 1
`
6. Touch the static-protective package that contains the new optical drive to any
unpainted metal surface on the server; then, remove the optical drive from the
package and place it on a static-protective surface.
7. Follow the instructions that come with the drive to set any jumpers or
switches.
8. Attach the drive retention clip that you removed from the optical drive filler
panel to the side of the new optical drive.
9. Align the optical drive in the drive bay and slide the optical drive into the
optical drive bay until the optical drive clicks into place.
Drive retention clip
Alignment pins
Figure 91. Optical drive retention clip installation
Chapter 5. Removing and replacing components 165
To Next Page
Loading...
Need help?
General
