8. Rotate the retention latch to the close position.
Note: Fasten the screw on the retention latch to secure the adapter.
9. If you are installing a full-height, full-length adapter, insert the shipping
brackets.
10. Connect any required cables to the adapter.
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components that are under
the riser-card assembly.
v Make sure that cables are not pinched by the server components.
11. Align the riser-card assembly with the selected PCI connector on the system
board and align it with the slots on the chassis; then, lower it into the server
and press down firmly until the riser-card assembly is seated correctly in the
connector on the system board.
v For half-length and low profile adapters
1
3
2
Adapter
Adapter connector
Expansion-slot cover
Bracket
PCI riser-card assembly
Figure 122. Adapter installation
Shipping bracket
PCI riser assembly
Figure 123. Full-height, full-length adapter
Chapter 5. Removing and replacing components 193
To Next Page
Loading...
