12. Perform any configuration tasks that are required for the adapter.
13. Reinstall the top cover (see “Replacing the top cover” on page 147).
14. Slide the server into the rack.
15. Reconnect the power cords and any cables that you removed.
16. Turn on the peripheral devices and the server.
Replacing an adapter in PCI expansion slot 4 or slot 5:
Use this section to replace an adapter in PCI expansion slot 4 or slot 5.
About this task
To replace an adapter, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables.
3. Remove the server top cover (see “Removing the top cover” on page 146).
4. ▌1▐Rotate the bracket to the open position.
5. Slide the expansion-slot cover out of the server.
PCI riser-card
assembly 2
PCI riser-card
assembly 1
Shipping bracket for
riser-card assembly
Figure 125. Riser-card assembly installation - full-height, full-length adapters
Chapter 5. Removing and replacing components 195
To Next Page
Loading...
