Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 283.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables.
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For details about handling these devices,
see “Handling static-sensitive devices” on page 285.
3. Remove the top cover (see “Removing the top cover” on page 146).
4. Remove the air baffle (see “Removing the air baffle” on page 148).
5. If you are replacing microprocessor 1, remove the memory modules from
DIMM connectors 6 and 7. If you are replacing microprocessor 2, remove the
memory modules from DIMM connectors 18 and 19. See “Removing a
memory module” on page 166 for instructions.⌂
6. Rotate the heat sink retention module release lever to the open position.
7. Open the microprocessor socket release levers and retainer:
Retainer bracket
Heat sink
release lever
Lock tab
Figure 225. Heat-sink lever rotation
266 System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
