40000013-00000000 Remote access attempt failed. Invalid userid or password received. Userid is [arg1] from
TELNET client at IP address [arg2].
Explanation: This message is for the use case where a user has failed to log in to a Management Controller from a
telnet session.
May also be shown as 4000001300000000 or 0x4000001300000000
Severity: Info
Alert Category: System - Remote Login
Serviceable: No
CIM Information: Prefix: IMM and ID: 0019
SNMP Trap ID: 30
Automatically notify Support: No
User response: Make sure that the correct login ID and password are being used.
40000014-00000000 The [arg1] on system [arg2] cleared by user [arg3].
Explanation: This message is for the use case where a Management Controller Event Log on a system is cleared by
a user.
May also be shown as 4000001400000000 or 0x4000001400000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0020
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
40000015-00000000 Management Controller [arg1] reset was initiated by user [arg2].
Explanation: This message is for the use case where a Management Controller reset is initiated by a user.
May also be shown as 4000001500000000 or 0x4000001500000000
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0021
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
40000013-00000000 • 40000015-00000000
324
System x3650 M5 Type 5462: Installation and Service Guide
To Next Page
Loading...
Need help?
General
