Table 7. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, Type 7377 server,” on page 125 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Message Severity Description Action
DHCP[%1] failure, no IP
address assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
Info A DHCP server has failed to assign
an IP address to the IMM.
1. Make sure that the network
cable is connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the
IMM.
ENET[0] DHCP-HSTN=%1,
DN=%2, IP@=%3, SN=%4,
GW@=%5, DNS1@=%6.
(%1 =
CIM_DNSProtocolEndpoint.
Hostname;
%2 =
CIM_DNSProtocolEndpoint.
DomainName; %3 =
CIM_IPProtocolEndpoint
IPv4Address;
%4 =
CIM_IPProtocolEndpoint.
SubnetMask;
%5 = IP address,
xxx.xxx.xxx.xxx;
%6 = IP address,
xxx.xxx.xxx.xxx)
Info The DHCP server has assigned an
IMM IP address and configuration.
No action; information only.
ENET[0]
IP-Cfg:HstName=%1,
IP@%2, NetMsk=%3,
GW@=%4. (%1 =
CIM_DNSProtocolEndpoint.
Hostname; %2 =
CIM_StaticIPSettingData.
IPv4Address; %3 =
CIM_StaticIPSettingData.
SubnetMask; %4 =
CIM_StaticIPSettingData.
DefaultGatewayAddress)
Info An IMM IP address and
configuration have been assigned
using client data.
No action; information only.
Ethernet Data Rate modified
from %1 to %2 by user %3.
(%1 = CIM_Ethernet
Port.Speed; %2 =
CIM_EthernetPort.Speed;
%3 = user ID)
Info A user has modified the Ethernet
port data rate.
No action; information only.
96 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
