5. Install the server into the rack enclosure and tighten the two front thumbscrews
to secure the server in the rack.
Attention: Two or more people are required to install the system in a rack
cabinet.
6. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Rotating the optional hot-swap rear hard disk drive cage up
To rotate the optional hot-swap hard disk drive cage up, complete the following
steps.
1
3
1
2
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 133.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Remove the cover (see “Removing the cover” on page 145).
Chapter 5. Removing and replacing server components 147
To Next Page
Loading...
