Release latch
1
2
3
Attention: If you need to replace the 3.5-inch hot-swap hard disk drive
backplane, be sure to take off the bracket by removing the 4 screws attached
and keep the bracket for further usage.
Hot-swap backplane bracket
Hot-swap backplane
Screws
9. If you are instructed to return the backplane, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Installing the 3.5-inch HS HDD backplane
To install the replacement hot-swap hard disk drive backplane, complete the
following steps:
1. If the backplane bracket has not been installed, attach the bracket onto the
backplane with four screws.
Chapter 5. Removing and replacing server components 197
To Next Page
Loading...
