4. Press down on blue touch points on the PCI riser-card assembly to install the
assembly in the server. Make sure that the PCI riser-card assembly is fully
seated in the PCI connectors on the system board.
Attention: Make sure that the cables are not pinched.
5. Install the server cover (see “Installing the cover” on page 146).
6. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Removing a riser card on the PCI riser-card assembly
To remove a PCI riser card from the PCI riser-card assembly, complete the
following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 133.
2. Turn off the server and peripheral devices and disconnect all power cords and
external cables.
3. Remove the server cover (see “Removing the cover” on page 145).
4. Remove the PCI riser-card assembly (see “Removing the PCI riser-card
assembly” on page 150).
5. Remove any adapter on the PCI riser-card assembly (see “Removing an
adapter from the PCI riser-card assembly” on page 156).
6. If you are removing PCI riser card 2 that contains the PCI Express Gen 2 x8
connector, you may remove the remote battery trays to obtain more room (see
step 5 on page 170 of the “Removing a ServeRAID controller battery from the
remote battery tray” on page 170 procedure).
7. Loosen the screws that secure the PCI riser card to the PCI riser-card
assembly.
The following illustration shows how to remove PCI riser card 1 from the PCI
riser-card assembly:
152 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
