Table 7. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, Type 7377 server,” on page 125 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Message Severity Description Action
Memory Logging Limit
Reached for DIMM n Status
on Memory Subsystem
DIMM n Status.
(n = DIMM number)
Error The memory logging limit has been
reached.
1. Check the IBM support website
for an applicable retain tip or
firmware update that applies to
this memory error.
2. Swap the affected DIMMs (as
indicated by the error LEDs on
the system board or the event
logs) to a different memory
channel or microprocessor (see
“Installing a memory module” on
page 162 for memory
population).
3. If the error still occurs on the
same DIMM, replace the
affected DIMM.
4. (Trained service technician only)
If the problem occurs on the
same DIMM connector, check
the DIMM connector. If the
connector contains any foreign
material or is damaged, replace
the system board (see
“Removing the system board”
on page 228 and “Installing the
system board” on page 230).
5. (Trained service technician only)
Remove the affected
microprocessor and check the
microprocessor socket pins for
any damaged pins. If a damage
is found, replace the system
board (see “Removing the
system board” on page 228 and
“Installing the system board” on
page 230).
6. (Trained Service technician
only) Replace the affected
microprocessor (see “Removing
a microprocessor and heat sink”
on page 221 and “Installing a
microprocessor and heat sink”
on page 223).
102 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
