v After you replace the battery, you must reconfigure the server and reset the
system date and time.
v To avoid possible danger, read and follow the following safety statement.
v To order replacement batteries, call 1-800-IBM-SERV within the United States,
and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your support center or business partner.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
See the IBM Environmental Notices and User's Guide on the IBM Documentation
CD for more information.
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Tilt the battery so that you can insert it into the socket on the side opposite the
battery clip.
3. Press the battery down into the socket until it clicks into place. Make sure that
the battery clip holds the battery securely.
4. Install the PCI riser-card assembly (see “Installing the PCI riser-card assembly”
on page 151).
5. Install the cover (see “Installing the cover” on page 146).
6. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
144 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
