Microprocessor
Handle
Installation
tool
i. Carefully align the microprocessor installation tool over the microprocessor
socket. Twist the handle of the microprocessor tool counterclockwise to insert
the microprocessor into the socket.
Attention: The microprocessor fits only one way on the socket. You must
place a microprocessor straight down on the socket to avoid damaging the
pins on the socket. The pins on the socket are fragile. Any damage to the
pins may require replacing the system board.
Installation
tool
Microprocessor
Alignment
holes
Screws
Handle
j. Close the microprocessor bracket frame.
k. Carefully close the microprocessor release lever to secure the
microprocessor in the socket.
226 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
