3. Select the settings to view or change.
Setup utility menu choices
The following choices are on the Setup utility main menu. Depending on the version
of the firmware, some menu choices might differ slightly from these descriptions.
v System Information
Select this choice to view information about the server. When you make changes
through other choices in the Setup utility, some of those changes are reflected in
the system information; you cannot change settings directly in the system
information.
– System Summary
Select this choice to view configuration information, including the ID, speed,
and cache size of the microprocessors, machine type and model of the server,
the serial number, the system UUID, and the amount of installed memory.
When you make configuration changes through other options in the Setup
utility, the changes are reflected in the system summary; you cannot change
settings directly in the system summary.
– Product Data
Select this choice to view the system-board identifier, and the revision level or
issue date of the integrated management module firmware and diagnostics
code.
v System Settings
Select this choice to view or change the server component settings.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings. To configure
memory mirroring, select System Settings → Memory , and then select
Memory Channel Mode → Mirroring.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports; configure remote console
redirection; enable or disable integrated Ethernet controllers, the SAS/SATA
controller, SATA optical drive channels, and PCI slots; and view the system
Ethernet MAC addresses. If you disable a device, it cannot be configured, and
the operating system will not be able to detect it (this is equivalent to
disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and
power utilization).
Note: When you change from Custom Mode to Performance Mode and back
to Custom Mode again, the Turbo Mode field still displays in the screen. You
cannot configure Turbo Mode settings in Custom Mode. To have this screen
display configurable fields properly, you may restore the Setup utility to the
factory default settings.
– Integrated Management Module
236 IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
