Icom IC-9700 - Page 100

9-12
9. D-STAR OPERATION (BASIC)
Updating the repeater list
Step 4: Removing the SD card
Turn OFF the transceiver, then remove the SD card
from your PC, and insert it into the transceiver’s slot.
Step 5: Updating the repeater list
1. Open the IMPORT/EXPORT screen.
MENU
» SET > SD Card > Import/Export
2. Touch “Import.”
SD card
Transceiver
From the memory
card reader
PC
TIP: We recommends that you save the current
data before loading other data into the transceiver.
3. Touch “Repeater List.”
4. Touch the CSV file to be loaded.
(Example: 9700_USA_Rpt_yymmdd)
5. Touch [YES] or [NO].
• YES: Retains the skip settings of the repeater list.
(See page 10-25)
• NO: Does not retain the skip settings of the
repeater list.
6. Touch “YES.”
• Starts the import.
• After importing ends, “COMPLETED!” is displayed.
7. To complete the importing, reboot the transceiver.
Step 3: Copying the CSV le to the SD card
1. Double-click the “9700_USA_yymmdd” folder
created in the same place where the downloaded
file is saved.
2. Copy the CSV file (Example: “9700_USA_Rpt_
yymmdd. csv”) in the folder and paste it in the
“RptList” folder (“IC-9700” > “Csv” > “RptList”) of
the SD card.
Paste the copied
CSV le in this folder.
TIP: If you copy the ICF le to the “Setting” folder
of the SD card, the repeater list can be updated
with the same procedures. In that case, select
“Load Setting” on the SD CARD screen. And on the
LOAD FILE screen, select “Repeater List Only.”
MENU
» SET > SD Card > Load Setting