Icom IC-9700 - SCAN SET Screen

5-3
5. SCANS
Pause Timer (Default: 10sec)
When Scan Resume is ON, select the Scan Pause
Timer. When receiving a signal, the scan pauses for
this set period of time.
• 2 ~ 20sec: When a signal is received, the scan
pauses for 2 ~ 20 seconds (in 2
second steps).
• HOLD: The scan pauses on a received
signal until the signal disappears.
Resume Timer (Default: 2sec)
Select the scan Resume Timer. When a received
signal disappears, the scan resumes after this set
period of time passed.
• 0sec: The scan resumes immediately after the
signal disappears.
• 1 ~ 5sec: The scan resumes 1 ~ 5 seconds after the
signal disappears.
• HOLD: The scan remains paused for the
Pause Timer setting, even if the signal
disappears.
Temporary Skip Timer (Default: 5min)
Set the Temporary Skip Timer. The unwanted
frequencies that are set as Skip channels (PSKIP or
SKIP) are skipped for this set period of time during a
scan.
L This timer is activated for the VFO scan, Memory scan,
and DR scan.
• 5min/10min/15min: Skip channels are skipped
for the set period of time.
• While Scanning: Skip channels are skipped
until the Scan is stopped.
• While Powered ON: Skip channels are skipped
until the receiver power is
turned OFF.
SCAN SET screen
1. Display the SCAN screen.
MENU
» SCAN
2. Touch [SET].
3. Touch an item to set. (Example: SCAN Speed)
4. Touch an option. (Example: Slow)
5. To close the SCAN SET screen, push
EXIT
.
TIP: How to reset to the default settings
Touching an item or its option for 1 second displays
the Quick menu, and then touch “Default” to reset
to the default setting.
SCAN Speed (Default: Fast)
Set the desired scan speed to slow or fast.
• Slow: Scan speed is slow.
• Fast: Scan speed is fast.
SCAN Resume (Default: ON)
Set the Scan Resume function to ON or OFF.
• OFF: When a signal is detected, cancels the scan.
• ON: When a signal is detected, the scan pauses
for 10 seconds, then resumes.
Two seconds after the signal disappears, the
scan resumes.