Icom IC-9700 - D Troubleshooting for the Access Point Mode Operation

11-22
11. ABOUT THE DV GATEWAY FUNCTION
Troubleshooting
D Troubleshooting for the Access Point mode operation
The following chart is designed to help you correct problems which are not equipment malfunctions.
If you are unable to locate the cause of a problem or solve it through the use of this chart, contact your Icom
Dealer or Service Center.
PROBLEM POSSIBLE CAUSE SOLUTION REFERENCE
After your call, the repeater
does not return a status reply.
(No S-meter indication)
• The wrong Access Point is selected
in the Remote D-STAR transceiver.
• Set the correct Access Point to
“FROM.”
–
• The manually entered frequency
or duplex setting is wrong in the
Remote D-STAR transceiver.
• Set the correct frequency or duplex
setting.
–
• The transmission from the Remote
D-STAR transceiver did not reach
the Access Point.
• Move to the place where the
Remote D-STAR transceiver can
reach the Access Point.
–
• Transceiver connection is wrong. • When using the Internal Gateway
function, check the connection
between the transceiver and the
router.
p. 11-8
• When using the External Gateway
function, check the connection
between the transceiver and the
Windows device, or the transceiver
and the Android device.
pp. 11-10, 11-11
• The Remote D-STAR transceiver’s
call sign has not been added to
“Allowed Call Sign List” in the
transceiver, RS-MS3W, or RS-
MS3A, when “Allowed Call sign” is
set to “Enable.”
• When using the Internal Gateway
function, add the Remote D-STAR
transceiver’s call sign to “Allowed
Call Sign List” in the INTERNAL
GATEWAY SETTINGS screen.
p. 11-8
• When using the External Gateway
function, add the Remote D-STAR
transceiver’s call sign to “Allowed
Call Sign List” in the RS-MS3W or
RS-MS3A.
RS-MS3W,
RS-MS3A’s
instruction
manual
• When using the External Gateway
function, you did not click (touch)
<Start>
in the RS-MS3W or
RS-MS3A.
• Click (touch) <Start>
in the RS-
MS3W or RS-MS3A.
RS-MS3W,
RS-MS3A’s
instruction
manual
After your call, the repeater
replies “UR?,” the Access
Point call sign and ID sufx
“G.”
• The call was successfully sent to
the Access Point, but no station
immediately replied.
• Wait for a while, and try again. –