Icom IC-9700 Advanced Manual

11-7
11. ABOUT THE DV GATEWAY FUNCTION
D When connecting your device to the Internet using a mobile router
Setting up a network
The following items are needed to use the DV
Gateway function.
• An Internet connection with an IPv4 Global IP address
• A static*
1
local IP address set to your Windows or
Android device
• Port forwarding of port 40000
1. A Global IP address
A static or dynamic IPv4 Global IP address assigned to the mobile router is needed.
L Your router may not have a Global IP address, depending on your Internet service provider.
Ask your Internet service provider about the Global IP address setting.
2. Setting a static local IP address
When using a mobile router, you need to set a static local IP address to Windows or Android device.
L Usable IP addresses differ, depending on your router. Ask the router’s manufacturer for details.
L Do not set the same IP address to two or more devices that are connected to the same router.
L Ask your Windows or Android device’s manufacturer about the setting details.
3. Port forwarding
When using a mobile router, enable communication with the Internet, as described below.
• Forward the port number 40000 to your Windows or Android device.
• “UDP” should be used as the port protocol.
• Set a static local IP address in Procedure 2 (2. Setting a static local IP address to your device) as a destination
port.
L Ask the router’s manufacturer about how to forward the port.
L Only one Windows or Android device connected to the router can use the DV Gateway function at the same time.
L Depending on the router settings, you may need to congure the IP lter settings. Check the router’s manual on how to
congure the settings.
 When using a Windows device, go to “Setting up the RS-MS3W.” (p. 11-10)
 When using an Android device, go to “Setting up the RS-MS3A.” (p. 11-11)
InternetInternet
OPC-
2350LU
OPC-
2350LU
*
1
A static IP address to the transceiver, Windows, or Android
device is recommended.
*
2
Forward port number 40000.
*
1
*
1
*
2
*
2
Needs a Global IP address.
Needs a Global
IP address.

Icom IC-9700 Specifications

General

Receiver Type	Triple conversion superheterodyne
Display	4.3 inch color TFT touch screen
Type	VHF/UHF/1.2GHz All Mode Transceiver
Receiver System	Triple conversion superheterodyne
D-STAR	Yes
Antenna Impedance	50 ohms
Power Supply	13.8V DC ±15%
Frequency Range	144-146 MHz, 430-440 MHz, 1240-1300 MHz
Mode	FM, SSB, CW, AM
Antenna Connector	2m/70cm: SO-239, 23cm: Type-N
Dimensions	240 x 94 x 238 mm
Weight	Approx. 4.7 kg
RF Power Output	2m/70cm: 100W, 23cm: 10W
GPS	Yes (Internal)
Sensitivity	0.18 μV (FM)