Icom IC-9700 - D Directly Entering (UR); D Directly Entering (RPT)

10-9
10. D-STAR OPERATION (ADVANCED)
D Directly entering (RPT)
The destination repeater call sign can be directly
entered.
NOTE: BE SURE to include a “/” at the beginning
and the node letter as the 8th digit. See page 10-27
“NOTE” about the node letters.
Example: Directly entering the call sign “/JP3YDHA.”
1.
Touch “TO” to select, then open the TO SELECT screen.
2. Touch “Direct Input (RPT).”
3. Enter a repeater call sign of up to 8 characters,
including spaces.
4. After entering, touch [ENT].
• Returns to the DR screen, and “/JP3YDHA” is set in
“TO.”
L After entry, you can correct the call sign in the
DIRECT INPUT (RPT) screen.
L The entered call sign remains on the DIRECT INPUT
(RPT) screen, until you enter a new call sign.
“TO” (Destination) setting
D Directly entering (UR)
The destination station call sign can be directly
entered.
Example: Directly entering the call sign “JM1ZLK.”
1. Touch “TO” to select, then open the TO SELECT screen.
2. Touch “Direct Input (UR).”
3. Enter the station’s call sign of up to 8 characters,
including spaces.
4. After entering, touch [ENT].
• Returns to the DR screen, and “JM1ZLK” is set in
“TO.”
L After entry, you can correct the call sign in the
DIRECT INPUT (UR) screen.
L The entered call sign remains on the DIRECT INPUT
(UR) screen, until you enter a new call sign.
TIP: If the entered call sign has a duplicate in the
“Your Call Sign” memory, the name is displayed.
(Only when the name has been entered.)