Icom IC-9700 - D Setting the GPS Alarm Function to RX (a Caller Station)

8-28
8. GPS OPERATION (ADVANCED)
GPS Alarm
D Setting the GPS Alarm function to RX
(a caller station)
1. Open the GPS ALARM screen.
MENU
» GPS > GPS Alarm
2. Touch “Alarm Select.”
3. Touch “R X .”
L If you want to set the alarm to a specic GPS
Memory, touch “Memory” and then select a GPS
Memory in a GPS Memory group.
4. To close the GPS ALARM screen, push
EXIT
several times.
L Information
• When a station with its GPS Alarm set enters
within an approximate 1 kilometer (1094 yard)
range, the alarm sounds once. When it enters
within an approximate 500 meter (547 yard) range,
the alarm sounds 3 times.
• When the transceiver sounds a GPS Alarm, “GPS
ALARM” pops up on the screen, and “ ” blinks.
See the illustration below.
• To cancel the GPS Alarm function, touch “OFF” in
step 3 to the left.
“GPS ALARM” pops up on the screen and the
alarm sounds, depending on the set range.
TIP: When selecting “RX” or a specic GPS
Memory in step 3 to the left, you also have to set
Alarm Area (RX/Memory) to use the GPS Alarm
function.
MENU
» GPS > GPS Alarm > Alarm Area (RX/Memory)
NOTE: Even if “RX” is selected in step 3, when the
received signal has no position data, the GPS Alarm
does not sound.
Blinks