Icom IC-9700 - Memory Scan; D Memory Scan Operation; D Setting the Select Memory Channels

5-5
5. SCANS
Memory scan
Memory scan
Ch 99
Blank channels are skipepd
Ch 1 Ch 2 Ch 3 Ch 4
Ch 5
Ch 6Ch 7Ch 50Ch 98
Repeatedly scans all entered Memory channels
(except1A/1B ~ 3A/3B, C1 and C2).
Blank (not entered) Memory channels are skipped.
L If two or more Memory channels are not entered,
the Memory scan does not start.
D Memory scan operation
1. Select the Memory mode.
2. Display the SCAN screen.
MENU
» SCAN
3. Touch [MEMO] for 1 second.
4. Touch [MEMORY SCAN].
Blinks
• Memory scan starts.
L When a signal is detected, the scan pauses
according to the “SCAN Resume” setting, and then
resumes.
LTo cancel the scan, touch [MEMO] again.
5. To close the SCAN screen, push
EXIT
.
Select Memory scan
Ch 1
★1
Ch 2
★2
Ch 7
★2
Ch 6
★1
Ch 5
★1
Ch 4
★1
Ch 3
★1
Ch 50
★3
Ch 98
★1
Ch 99
★1
“★1,” “★2” and “★3” show that the channel
is specified as a Select Memory.
(Example: Select Memory channel ★1)
Repeatedly scans Select Memory channels (★1,
★2, ★3).
L If two or more Memory channels are not
designated as Select Memory channels, the
Select Memory scan does not start.
D Setting the Select Memory channels
1. Select the Memory mode.
2. Display the MEMORY screen.
MENU
» MEMORY
3. Touch the SELECT icon to set the channel as the
Select Memory channel. (Example: ★1)
• Each touch selects “1,” “2,” “3,” and “(no icon).”
“1” is set to Memory channel 1.
Touch to set the channel as a Select Memory channel.
L Setting Select Memory channels on the SCAN
screen.
1. Push
kHz
M-CH
.
2. Rotate
MULTI
to select memory channels to set
as Select Memory channels. (Example: ★1)
3. Touch [SELECT] to set the selected number.
“1,” “2,” “3,” and “(no icon)” are alternately
displayed.
4. Repeat steps 2 and 3 to set more than two Select
Memory channels.