2-5
2. VOICE RECORDER FUNCTIONS
RECORDER SET screen
You can change the recorder settings on this screen.
» RECORD > RECORDER SET
TX REC Audio (Default: Direct)
Select the transmit audio to record.
• Direct: Records the microphone audio.
• Monitor: Records the TX monitor audio.
RX REC Condition (Default: Squelch Auto)
Select the recording setting for receive.
• Always: Records even if no signal is received.
• Squelch Auto: Records only when the squelch
opens.
(The recording will be paused when
the squelch closes while recording.)
File Split (Default: ON)
Turn the File Split function ON or OFF.
• OFF: The audio is continuously recorded into
the le even if you switch between transmit
and receive or the squelch status changes
between open and closed.
When the recording le’s size becomes
2 GB, the transceiver continues to record, but
to a new le.
• ON: While recording, if you switch between
transmit and receive, or the squelch status
changes between open and closed, a new le
is automatically created in the same folder,
and the audio is saved into the new one.
REC Operation (Default: MAIN/SUB Link)
Select the recording operation on the dual band display.
• MAIN/SUB Separate: The recording function is
separately active/inactive
on the selected band (MAIN
band) when the function is
started or stopped.
• MAIN/SUB Link: The recording function is
simultaneously active/inactive
on both MAIN and SUB
bands when the function is
started or stopped.
L On the single band display,
only displayed band (MAIN or
SUB) is recorded.
PTT Auto REC (Default: OFF)
Turn the PTT Automatic Recording function ON or
OFF.
• OFF: The recording does not start, even if a signal
is transmitted.
• ON: The recording automatically starts when a
signal is transmitted.
The recording will stop when:
• 10 seconds has passed after the last transmission.
• 10 seconds has passed if no signal is received after the
last transmission.
- If you receive a signal within 10 seconds after the last
transmission, the received audio is also recorded.
- If you receive another signal within 10 seconds after the
last reception, the received audio is also recorded.
• 10 minutes has past while operating with the squelch is
open in the SSB, CW, RTTY, or AM mode.
• The frequency or operating mode is changed.
PRE-REC for PTT Auto REC (Default: 10sec)
Select whether or not to record the audio that is
received before the PTT Automatic Recording
function is activated.
• OFF: Does not record the audio.
• 5sec/10sec/15sec:
Records the audio that is previously received
in this set period of time.
TIP: How to reset to the default setting
Touching the item or its option for 1 second displays
the Quick menu, and then touch “Default” to reset to
the default setting.
To Next Page
Loading...
