Icom IC-9700 - Entering Memory Channel Contents

4-2
4. MEMORY OPERATION
Entering memory channel contents
1. Push
V/M
to select the VFO mode.
2. Set the frequency and operating mode.
3. Hold down
kHz
M-CH
for 1 second.
“M-CH” is
selected
4. Rotate
MULTI
to select the Memory channel to
enter the contents set in step 2. (Example: 2)
L If “BLANK” is displayed under the selected memory
channel number, it is a blank channel, meaning that
no contents are entered in that channel.
5. Touch the Memory channel number.
6. Touch [MW] for 1 second until BLANK disappears
from below the channel number.
• The contents are entered in the selected Memory
channel, and BLANK is not displayed below the
channel number.
7. To close the VFO/MEMORY screen, push
EXIT
.
The operating frequency, operating mode, IF lter bandwidth, and so on can be entered to each memory channel.
NOTE: New content you enter will overwrite any
content already in the selected memory.