11-15
11. ABOUT THE DV GATEWAY FUNCTION
Access Point mode operation
D Making a Gateway call through the Access point transceiver
In this section, set up a Remote D-STAR transceiver you are going to operate.
L Read the Remote D-STAR transceiver’s instruction manual for setting details.
NOTE: While in the Access Point mode, you can
make a Gateway CQ call or a call to an individual
station using call sign routing.
L You can select the “Local CQ,” but cannot make a call.
Example: When setting the operating frequency
to 430.850 MHz, and making a Gateway
CQ call.
*
1
Any model as long as the transceiver is D-STAR capable.
Only one D-STAR transceiver can use the Access Point
at a same time.
*
2
When you use the External Gateway function, enter the
Call sign in “Terminal/AP Call sign” in the RS-MS3W or
RS-MS3A.
When using the DR function
NOTE: If you have imported the Repeater List, you
have to register the Access Point information again
because the Repeater List is overwritten.
In this document, the ID-51A (PLUS2)/ID-51E
(PLUS2) is used as a Remote D-STAR transceiver as
an example.
1. Register the Access Point information to the
Repeater List
L Register the Access Point information in the MENU
screen.
(MENU > DV Memory > Repeater List)
1. Select a group you want to add your Access Point
information to.
2. After selecting a group, open the Repeater List
Edit screen. (QUICK MENU > Add)
InternetInternet
Operating frequency:
430.850 MHz
MY Call Sign:
JA3YUA
Terminal/AP Call sign*
2
:
JA3YUA D
Access point
Remote D-STAR
transceiver*
1
Operating
frequency:
430.850 MHz
UR: /JP1YIU A
MY: JL3YRP
Hamacho 430
(JP1YIU A)
Other
station
3. Set “DV Repeater” to “TYPE.”
L “DV Repeater” is used for Repeater operation in the
DV mode.
4. Enter your favorite name into “NAME” and “SUB
NAME.” (Example: MY AP)
5. Set the Access Point transceiver’s call sign to
“CALL SIGN.” (Example: JL3YRP)
L After setting “CALL SIGN,” “GW CALL SIGN” is
automatically set.
To Next Page
Loading...
Need help?
General
