Icom IC-9700 - Page 162

11-23
11. ABOUT THE DV GATEWAY FUNCTION
Troubleshooting
D Troubleshooting for the Access Point mode operation
PROBLEM POSSIBLE CAUSE SOLUTION REFERENCE
After your call, the repeater
replies “RX” or “RPT?” and
the Access Point call sign and
ID sufx “G.”
• The Remote D-STAR transceiver’s
call sign has not been set to the
transceiver.
• Set the Remote transceiver’s
call sign has not been set to the
transceiver.
The Remote
D-STAR
transceiver’s
instruction
manual
• The Remote D-STAR transceiver’s
call sign has not been registered at
a gateway server.
• Register The Remote D-STAR
transceiver’s call sign at a gateway
server.
• The Terminal/AP call sign that is set
in the transceiver, RS-MS3A, or RS-
MS3W has not been registered to
the RS-RP3C as the access point.
• When using the Internal Gateway
function, register the Terminal/AP
call sign that is set in the transceiver
to the RS-RP3C as the access point.
p. 11-8
• When using the External Gateway
function, register the Terminal/AP
call sign that is set in the RS-MS3A
or RS-MS3W to the RS-RP3C as
the access point.
RS-MS3W,
RS-MS3A’s
instruction
manual
• Destination station’s call sign (UR)
has not been registered to the
gateway server, or the registered
contents do not match your
transceiver’s setting.
• Check the destination station’s
register information.
–
• A wrong destination repeater’s call
sign is set to “TO.”
• Set the correct destination
repeater’s call sign to “TO.”
p. 11-15
• The settings are wrong. • When using the Internal Gateway
function, correctly set the
transceiver’s Internal Gateway
settings.
p. 11-8
• When using the External Gateway
function correctly set the RS-MS3W
or the RS-MS3A.
RS-MS3W,
RS-MS3A’s
instruction
manual
• Destination station that uses the
Terminal mode or Access Point
mode does not transmit periodically.
• Destination station makes a call. –
After your call, the repeater
replies ’RPT?’ and the access
repeater’s call sign.
• The repeater cannot connect to the
destination repeater.
• The repeater is busy.
• Wait for a while, and try again. –
“L” appears on the LCD. • While receiving through the Internet,
some packets may be lost due to
network error (poor data throughput
performance).
• Wait for a while, and try again.
L When the transceiver receives
corrupted data, and misidenties
it is as Packet Loss, “L” is
displayed.
–
“DV” and “FM” icons
alternately blink.
• While in the DV mode, an FM signal
is received.
• Use a different operating frequency
until there are no FM signals on the
original frequency.
–
You can transmit, but cannot
receive from the destination
repeater.
• A Global IP address is not used. • Check the Internet connection and
use a Global IP address.
pp. 11-4 ~ 11-7
• The router or mobile router’s port is
not correctly forwarded.
• Forward the router or mobile
router’s correct port.
pp. 11-4, 11-7
• The rewall is blocking the
necessary port.
• Check your rewall settings. p. 11-10