11-17
11. ABOUT THE DV GATEWAY FUNCTION
Access Point mode operation
D Making a Gateway call through the Access point transceiver
When not using the DR function
In this document, the ID-51A (PLUS2)/ID-51E
(PLUS2) is used as a Remote D-STAR transceiver as
an example.
2. Set the operating frequency
Rotate [DIAL] to set the frequency that is set in the
Access Point transceiver. (Example: 430.850)
3. Set the Receive mode to “DV mode”
Push [MODE] several times until “DV” is displayed.
L When the “GPS TX Mode” is set, “DV-G” or “DV-A” is
displayed.
4. Set the duplex direction
1. Push [QUICK].
2. Select “DUP.”
1. Enter the VFO mode
Push [V/MHz].
3. Select “DUP–.”
To Next Page
Loading...
