Programming IDEC SmartRelay
99
IDEC SmartRelay Manual
IDEC SmartRelay shows the following display:
>On
Off
S/W Time:
On EU
IDEC SmartRelay indicates that European S/W Time con-
version is enabled.
User-defined parameters
If none of the parameters/conversions apply to your country,
you can customize these under menu item ‘. .’. To do so:
1. Confirm ‘On’ once again: Press OK
2. Move the ‘>’ cursor to ‘. .’: Press ▲ or ▼
3. Confirm the menu item ‘. .’ : PressOK
The display shows:
MM-DD
+ : 01-01
- : 01-01
=000min
0
Cursor / solid square
Month (MM) and Day (DD)
Start of summertime
End of summertime
The desired time zone difference in
[min]
Let us assume you want to configure the following parame-
ters: Start of summertime = 31st of March, end of summer-
time = 1st of November, time difference of 120 minutes.
This is how you can enter your data:
• Press
▲
or
▲
to move the solid square/cursor.
• Press ▲ or ▼ to change the value at the cursor position.
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...
Need help?
General
