IDEC SmartRelay installation and wiring
IDEC SmartRelay Manual 22
Removal
To remove the IDEC SmartRelay:
....... if you have installed only one IDEC SmartRelay Base:
Part A
1. Insert a screwdriver into the eyelet at the bottom of the
slide interlock and move the latch downward.
2. Swing the IDEC SmartRelay Base off the DIN rail.
1
2
1
2
3
4
AB
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...