Programming IDEC SmartRelay
73
IDEC SmartRelay Manual
I2 is now connected to the input of the OR block:
≥ 1
B1
Q1
≥
1
Q1
I1
I1
B1
I2
I2
The display now shows:
Your circuit program layout in
IDEC SmartRelay up to now
We do not need the last two inputs of the OR block for this
circuit program. You can mark the unused inputs with an 'x'.
Enter the 'x' character twice:
1. Switch to editing mode: Press OK
2. To select the Co list: Press ▼ or ▲
3. To accept the Co list: Press OK
4. To select 'x': Press ▼ or ▲
5. To apply x: Press OK
≥ 1
Q1
I1
B1
I2
Q1B1
x
The display now shows: This is the layout of your circuit
program
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com
To Next Page
Loading...