idp SMART-81 - Page 19

19
The below table shows LCD messages based on their status and functions when the button is
pressed.
Messages KEY0 KEY1 KEY2 KEY3 State Description
Menu/Can
cel
Left/Down Right/Up Select/OK
Initializing x x x x Initialization Initialization when
booting, or Case Open
and Close
Display Printer Firmware
Version, Vendor, Region
Code.
[x.xx.xx][xx][xx]
Init Error+ Retry
initializati
on
Retry
initialization
Retry
initialization
Retry
initialization
Initialization
error
Error occurs while
initialization.
press the Key and check
the error is clear, and
retry initialization.
‘+’ is displayed at the end
of first line if there are
more than two errors.
<-Retry->
SMART-81x x x x x Password
authentication
Use Authentication
option on Smart81 Config
utility, and printer is Lock
with Root Password/User
Password.
Unlock Please..
SMART-81x x x x x PC
authentication
Use Authentication
option on Smart81 Config
utility, and use SMART
printer with not
Authentication PC.
Verify Your PC
SMART-81x MENU Information
Menu -
Information
Menu +
x Standby
mode
System is ready to print,
you can check the ribbon
information by pressing
left button, and power is
off by pressing the right
button.
With the power off,
pressing right key again
will power on again (DCL
Mode)
DCL System Ready
SMART-81xx MENU Information
Menu -
Information
Menu +
x Standby
mode
System is ready to print,
you can check the ribbon
information by pressing
left button, and power is
off by pressing the right
button.
With the power off,
pressing right key again
will power on again.
(Normal Mode)
System Ready
TPH Not Found x x x x TPH connect
check
TPH is not installed or
TPH cable is not
connected. Power off the
Check TPH