idp SMART-81 - Page 99

99
(5) Retransfer film is stuck and does not fall off properly (side of the card)
 Non standard card
change the card.
 The card surface is uneven or contaminated
with the dust and dirt.
After checking the card, change it to another
card.
 Retransfer temperature setting doesn’t match
the card.
Raise the retransfer temperature to use
CardPrinterConfig.
 Worn-out printer.
Please contact the local supplier.
(6) Retransfer film is stuck and does not fall off properly. (end of the card)
 Non standard card.
change the card.
 Retransfer setting doesn’t match the card.
Change Retransfer condition setting to use
CardPrinterConfig.
 Feeding & printer roller contaminated with
the dust and dirt.
Clean roller with Cleaning kit as section 6.1
 Worn-out printer.
Please contact the local supplier.
(7) Fail side retransfer due to insufficient Overcoat while retransfer.
 Non standard card.
change the card.
 The card side surface is uneven or
contaminated with the dust and dirt.
After checking the card, change it to another
card.
 Retransfer temperature setting doesn’t
match the card.
Figure 104 Printing quality trouble 8
Figure 103
Printing quality trouble 7
Figure 102
Printing quality trouble
6