63
3
SETUP INFORMATION
302.061
The value of this parameter must be entered.
This is the value of point
C
(the facing point), i.e. the distance between the bar feeder’s short feed
gate 4 and the facing point.
The value of this parameter is self-learnt by the program.
This is the distance (mm) that the bar pusher has still to cover in order to reach point
C
, after the
bar’s 1st feeding.
61
*(mm)
( inches )
n o . 6 1 I NTRODUCT I ON V
ALUE ( X )
63
1375(mm)
( inches )
no.63 COLLET-FLAG DI
STANCE (B1C)
4
2
1
65
7 8
6
9 10
I
II
III
31.014 Ec.3
3
Legend:
I
-
Fixed headstock lathe
II
-
Sliding headstock lathe
III
-
Sliding steady rest lathe
1
-
Carriage “backwards”
2
-
Bar-pusher “backwards”
3
-
Carriage “forwards”
4
-
Short feed door
5
-
Bar-pusher “forwards”
6
-
Spindle
7
-
Headstock “backwards”
8
-
Headstock “forwards”
9
-
Steady rest “backwards”
10
-
Steady rest “forwards”
64
*(mm)
( inches )
no.64 COLLET VALUE (
C)
To Next Page