64
3
SETUP INFORMATION
302.061
The value of this parameter is self-learnt by the program.
Value given by adding the value of point
C
and the value of
parameter 2
.
The value of this parameter is self-learnt by the program.
This is the value of point
F
(the maximum bar pusher feed point), i.e. the distance between the bar
pusher’s rear end in the “completely backward” position and the maximum bar pusher feed point..
Position of the feeding carriage during the bar pusher lifting phase.
65
*(mm)
( inches )
no.65 COLLET+FACING
VALUE ( C I )
66
1350(mm)
( inches )
no.66 MAX. FEED VALU
E(F)
68
*(mm)
( inches )
no.68 GUIDE CHANNEL
OPEN I NG MAX . VALUE
To Next Page