IEMCA VIP 80 - Page 59

56
302.028
ANALYTICAL INDEX
A
Additional push-button panel, description of controls,
37
- push-button panel, installation, 24
Adjustment according to bar type, foreword, 27
- and set up, foreword, 26
- and setting up safety procedures, 14
- of the bar passage guide, 31
- of the bar pusher working position, 27
- of the bar selection, 29
- of the covering frame, 29
- of the feed chain, 26
- of the guide lifting limit switch, 30
- of the magazine inclination, 29
Air filter unit, check, 47
Alignment, levelling, 22
Annexes enclosed, 5
Automatic cycle, starting after manual cycle opera-
tions, 42
- cycle, starting after resuming work following a
switching off, 43
- cycle, starting, 40
Axial displacement device, description,13
B
Bar feeder and manufacturer, identification, 5
- feeder maintenance, safety procedures, 15
- feeder stop, 42
- feeder, general description, 6
- feeding, troubles, 50
- magazine, inclination adjustment, 29
- magazine, loading, 39
- magazine, troubles, 50
- passage guide (optional), adjustment, 31
- passage guide, installation, 23
- pusher working position, adjustment, 27
- pusher, adjustment of the working position, 27
- pusher, selection and installation, 31
- selection, adjustment, 29
- stock, characteristics and preparation, 38
Battery, keyboard, replacement, 53
C
Carriage, replacement of the back limit sensor, 52
Characteristics and preparation of the bar stock, 38
- of the bar feeder setting, 18
Checking the air filter unit, 47
- the revolving tip, 48
Controls of the additional push-button panel, descrip-
tion, 37
- of the push-button panel, description, 32
Covering frame, adjustment, 29
D
Description of models, 6
- of the axial displacement, 13
- of the controls of the additional push-button panel,
37
- of the controls of the push-button panel, 32
- of the main parts, 7
Diameter change-over of the reduction sleeves, 27
E
Electric connection power supply, connection, 24
- connection, 24
F
Feed chain, adjustment, 26
- chain, replacement, 52
- motor, drive replacement, 54
Fixing the bar feeder to the lathe, 22
G
General adjustments, foreword, 26
- description of the bar feeder, 6
- description of the working cycle, 8
- troubles, 50
Guide lifting limit switch, adjustment, 30
- , adjustment of the lifting limit switch, 30
H
Handling and installation, safety procedures, 14
Height, adjustment, 21
I
Identification of the manufacturer and the bar feeder,
5
Indicator lights, 44
Installation of the additional push-button panel, 24
- of the bar passage guide, 23
- , alignment and levelling, 22
- , fixing the bar feeder to the lathe, 22
- , foreword, 20
- , height adjustment, 21
- , positioning, 20
- , preparing the bar feeder, 19
K
Keyboard battery, replacement, 53
L
Lifting, 16
Loading the bar magazine, 39
Lubricating points, 49
M
Magazine inclination, adjustment, 29
Main parts, 7
Maintenance, general rules, 46
Manual purpose, 4
Manufacturer and bar feeder, identification, 5
Models, description, 6