57
ANALYTICAL INDEX
302.028
N
Noise levels, 12
O
Operation sequence for tooling and starting the auto-
matic cycle, 39
P
Packaging, 16
Periodic maintenance, table, 47
PLC battery replacement, 53
Pneumatic connection, 23
- supply, connection, 23
Position and description of the safety labels, 11
Positioning, 20
Preparation and characteristics of the bar stock, 38
Preparing the bar feeder for installation, 19
Program entry of the self-learning values, 24
Push-button panel, description of controls, 32
R
Reduction sleeve, diameter change-over, 27
Replacement of the carriage back limit sensor, 52
- of the feed chain, 52
- of the feed motor drive, 54
- of the keyboard battery, 53
- of the PLC battery , 53
- of the short feed door sensor, 55
Revolving tip, inspection, 48
S
Safety devices, 11
- labels, position and description, 11
- , general instructions, 14
Selection and installation of the bar pusher, 31
Self-learning values, entry into program, 24
Sensor of the carriage back limit, replacement, 52
- of the short feed door, replacement, 55
Setting the bar feeder, characteristics, 18
Short feed door, sensor replacement, 55
Starting the automatic cycle and tooling, operation se-
quence, 39
- the automatic cycle following manual cycle opera-
tions, 42
- the automatic cycle, 40
- the automatic cycle, resuming work following a
switching off, 43
T
Table of the periodic maintenance, 47
Technical assistance, 5
- specifications, 12
Tooling and starting the automatic cycle, operation se-
quence, 39
Troubles of the bar feeding, 50
- of the bar magazine, 50
U
Use and operation, safety procedures, 14
W
Working cycle, general description, 8
To Next Page
Loading...
