IEMCA VIP 80 - Page 88

26
2
INSTALLATION PROCEDURE
302.061
Sliding headstock lathes
: enter the headstock stroke value, ad-
ding some millimetres to avoid any contact between the bar-pu-
sher and the bar during machining.
0
- The parameter function is overridden.
>0
- When the set number of workpieces is reached, the bar feeder stops the lathe in “FEEDING”.
Value>0
- Example of application.
Set 1000 workpieces
it appears:
Start the working cycle.
After 1000 machined workpieces, the bar feeder stops the lathe.
it appears:
To reactivate the working cycle, the value within brackets must be reset.
0
- The parameter function is overridden.
>0
- After the set number of minutes, the bar feeder stops the lathe in “FEEDING”.
Headstock stroke
+2
÷
3 mm
Headstock stroke
31.060 Ec.1
26
Phase
machining
:>0
(0)
no.26 Workpieces pri
or to lathe stop
:>1000
(0)
no.26 Workpieces pri
or to lathe stop
:>1000
(1000)
no.26 Workpieces pri
or to lathe stop
27
Phase
machining
:>0 (min)
no.27 Minutes prior
to lathe stop