28
2
INSTALLATION PROCEDURE
302.061
Defines the language of the messages on screen.
• Italiano
• Français
• English
• Deutsch
• Español
1-
(RETURN)
2-
(K13 IMMEDIATE)
3-
(IMMEDIATE RETURN)
4-
(FEEDING)
5-
(K1 ENABLED)
INFORMATION: the five modes signals described below refer to parameter
21 in the 0 - “Removal” or 1 - “Ejection” mode. When parameter 21 is in the
2 - “Bar change advance” mode, the signals do not change but the bar feeder
behaves according to the description at this parameter.
30
Phase
/
:>1
no . 30 Language 1I - 2G
B-3D-4F-5E
31
Phase
machining/bar change
:>1
no.31 Bar feeder int
erface control
To Next Page
Loading...
