IHI 9NX - Switches

OPERATION
4. SWITCHES
@ Light Switch
Push down on the [&I marked of the switch to turn
the light on.
Push down on the blank half of switch to turn the
working light off.
a Engine Start Switch
If the engine does not start after 10
seconds, return the key to
OFF and wait
for two minutes before returning it to
START.
Stop Operation
OFF : The engine must be in the OFF position to
insert or remove the key. Turn the key switch to the
OFF position before trying to restart the engine. Turn
(HEAT)
the key switch to the OFF position to stop the engine.
ON : Turn the key clockwise to active the electrical
System. The key will return to the
ON position when
released from the
START position.
START : Turn the key to the START position to crank
Engine Start Switch
the engine. Release the key as soon as the engine
starts.
HEAT : In cold season, preheating is performed to
facilitate engine start. (This operation is unnecessary
if the engine is warm.) Setting the key to the Preheat
position starts heating the glow integrated into the
engine.
The preheating time should be 10 seconds or shorter.
(The glow may be burnt if preheating is performed for
more than 10 seconds.)
Turn the key to the Start position to start the engine
immediately after preheating.
Horn switch
@ Horn switch
Push down on the top of the right operating lever to
activate the horn.