MAINTENANCE
Change the Coolant
Coolant should be drained and changed every 250
service hours or six months. However, when adding
"Long-Life-Coolant", the drain period can be
extended to 2 years.
Drain the coolant earlier whenever the coolant is
dirty or foaming is observed.
See 3-9. 2 years Maintenance section.
Fan and Alternator Belt
Hot components can cause personal injury.
Stop the engine and remove the start switch
key.
Inspect
Stop the engine. lnspect the belt for wear and cracking.
To check the belt tension, Push the belt inward by hand
apply 98N
(10kg) force midway between the pulleys.
Correctly adjusted belt will deflect 1
Omm.
Adjust
1. To adjust the belt, loosen mounting bolt
a
and
0.
2. Move the alternator in or out as required to obtain
the correct adjustment.
3. Tighten mounting bolts
0
and
0.
4.
Check the belt adjustment again after
5
minutes of
engine operation at rated speed.
@
Reseerve tank
a
Radiator cap
.\
Drarn
cock
Fan pulley
a
Bolt Adjust plate
\
/
\
a
AC
generator
To Next Page
Loading...
