STARTING ENGINE
Once the pre-start inspection has been completed, the engine
may be started.
1. Move all attachment Controls to the
HOLD
position
before starting the engine.
2.
Move the engine throttle lever above the
LOW IDLE
position (advance about one-third to one-half).
3.
Turn the start switch key to the
START
position.
NOTE
:
Under low temperature conditions, turn the
start switch to
PRE-HEAT
for 10 seconds
BEFORE
turning to
START
position.
4.
Release the start switch key when the engine starts.
1. Do not engage the starter motor for more than
10 seconds at a time. Should the engine fail
to start within 10 seconds, allow the starter
motor to cool for
2
minutes, before attempting
to start the engine again.
Turn the key to
OFF
before trying to restart
the engine.
2.
Allow the engine to warm up until operating
temperature and required oil pressure are
obtained.
3.
Before attempting any working operations,
warm up the hydraulic oil as described in
'reoperation Warm-Up"
Engine
throttle lever
Operation
Preheat
Stop
(PN)
Start switch
DO NOT USE ETHER
FOR STARTING AID
To Next Page
Loading...
