Programming manual
Programming example 99
Via softwareClick on the Keys button then, on the section on the right, select the key corresponding to the
remote control by clicking on the corresponding button
.
The “Shortcuts” section will allow you to associate the shortcuts with the buttons.
11. Enroll the wireless keyfob via the simulated reader of the transceiver ([N], identified on
the keypad by the letter “W”).
Via keypad
PROGRAMMING Keys, Enroll, "READER 00x W", "Key 00x"
At this point you have 3 minutes to enroll the wireless keyfob by pressing simultaneously
buttons F3 and F4.
The positive outcome of the operation will be signalled by 3 blinks on the green LED of the
wireless keyfob and a long audible signal on the buzzer.
CLOSING THE
PROGRAMMING
SESSION
12. Close the programming session after saving the modified data.
Via keypad
Press the
Esc
several times until the following message appears on the display:
EXIT? OK = YES
On pressing OK you will automatically exit the programming session, save the programmed
data and reboot of the control panel.
Via softwareUsing the Write button carry out a write operation.
At the end of this operation the control panel will reboot and it will possible to close the
software solution in progress.
Table 22-5: Shortcuts for wireless keyfobs
Device Button Shortcut Parameter Default
O
F1
Arm/Disarm Scenario 1 “Away” Yes
F2
Arm/Disarm Scenario 2 “Disarm” Yes
F3
Activate output Cancel No
F4
Activate output Garden lights No
To Next Page
Loading...
