Insulet Omnipod Dash - Pod Sites Setting; Reminder Settings

Adjusting Settings 9
98
9 Adjusting Settings
To reset your PDM:
1. Prepare a list of your personalised settings so you can re-enter them aer you
reset your PDM. Consult with your healthcare provider to ensure that the
settings are appropriate for you.
Tip: Record your current settings on the pages at the end of this User Guide.
2. Navigate to: Settings icon ( ) > PDM Device > Reset PDM.
3. If you have an active Pod, tap DEACTIVATE POD, then tap DEACTIVATE POD
again.
4. Tap RESET PDM and then tap RESET PDM again.
is deletes your current user settings.
5. Follow the PDM setup directions in “Initial PDM Setup” on page 21 to re-
enter your personalised information or call Customer Care for assistance.
Pod Sites Setting
e Pod Sites setting controls whether a diagram of the body is available when you
activate a new Pod. You can use this body diagram during Pod activation to review
where you placed your recent Pods and to mark where you place the new Pod.
To turn the Pod Sites setting on or o:
1. Navigate to: Settings icon ( ) > Pod Sites.
2. Tap the toggle to turn the Pod Sites setting on or o. If you want the ability to
record your Pod site on the diagram, turn Pod Sites on. If you do not want to
use this diagram, turn it o.
3. Tap SAVE.
Reminder Settings
Reminders and notications bring items related to PDM and Pod function to
your attention (see “Notications List” on page 117 and “Informational Signals
List” on page 119).
Effective Date: 27SEP2019, ECO-000240