132
11 Taking Care of Your PDM and Pod
4. If a battery is in place, put your ngernail in the slot just below the battery
on the right-hand side and li out the battery.
5. Orientate the new battery so the three gold tabs on the battery line up with
the three gold pins in the battery compartment. e “-” and “+” signs on the
battery label should face you.
Caution: Do not remove the label from the
battery.
Caution: Be careful not to damage any
of the small metal parts inside the battery
compartment.
6. Slide the battery into place. Gently push the
bottom of the battery to t it into place.
7. To replace the back cover of the PDM:
a. Line up the cover’s edge along the side with the Sound/vibrate and Power
buttons. Press down on this side rst.
b. Press down along the back cover until the cover has clicked into place.
e PDM is now ready to use. If this is a new PDM, see “Initial PDM Setup” on
page 21 for instructions on entering your settings.
Note: If you replaced the battery in your current PDM, you must reset the time
and date (see “Date and time and language” on page95). Your history records
and personal settings will be saved.
Effective Date: 27SEP2019, ECO-000240
To Next Page
Loading...