USER MANUAL
INTEL® FALCON™ 8+ UAS
© 2017 Intel Corporation. All rights reserved 128
• JOYSTICK ERROR!
When the CTR is switched ON, the joysticks are calibrated automatically. If this
fails (e.g. because the user was pushing a joystick during turn-on or because
something is actually broken), this warning will appear.
Restart the CTR (take care not to exert pressure on any joystick) and see if the
warning is still active. If so, the joystick electronics may be broken. In this case
please get in touch with Intel support.
• Cockpit temperature high!
The temperature of the CTR exceeds the recommended operating temperature.
Check if something is blocking the fan's air stream and if the fan is working
properly. Turn OFF the CTR to let it cool down and switch it ON again. If the
problem persists, please get in touch with Intel support.
Status Display: CP. BAT.
EMPTY!
Tablet: Cockpit
battery empty. Land
now!
The battery of the CTR is
empty. Only a few minutes
remain until it will shut
down automatically.
Vibration on the CTR.
Acoustic: Battery empty.
Land now!
Visual: The remaining
operating time of the
CTR shown as a per-
centage on the Status
Display flashes.
Status Display: JOYSTICK
ERROR!
Tablet: Joystick
error. Land now!
The calibration of the con-
trol sticks failed (see below
for further information).
Vibration on the CTR.
Status Display: CP
TEMPERATURE!
Tablet: Cockpit
temperature high!
The CTR temperature is
outside of the allowed
range (see below for further
information).
Vibration on the CTR.
Table 3.12: Possible Warnings Which Refer To The CTR (Continued)
SHOWN TEXT REASON SIGNALS
To Next Page
Loading...
Need help?
General
