Intel FALCON 8 Plus

USER MANUAL
INTEL® FALCON™ 8+ UAS
© 2017 Intel Corporation. All rights reserved 133
Navigation
N2U:
Trajector
y flight
in
progress
-> CMD
ignored!
The user tried to
execute a survey
flight while a pre-
viously started
survey flight is
still ongoing. The
command sent to
the UAV will be
ignored and the
current survey
flight will be con-
tinued.
Abort the
ongoing sur-
vey flight and
send the new
flight parame-
ters again.
Calibration
No calib
on
payload
found
Timeout: Not
able to read a
payload calibra-
tion from camera
EEPROM within
15 seconds after
start-up. Usually
happening with
new Payloads /
Payloads never
calibrated on an
Intel® Falcon™ 8+
UAV.
Possibly bad yaw
alignment
Run payload
calibration. If
no success:
Check/ refor-
mat the USB
stick: Prob-
lems initializ-
ing the USB
stick could
make the PER
processor
stuck for too
long => Time-
out
Calibration
Invalid
payload
calib -
please
recalibra
te!
Payload calibra-
tion invalid. The
reason could be
that less than 3
IMUs were avail-
able during the
calibration pro-
cess.
Possibly bad yaw
alignment
Run payload
calibration
again.
Table 3.13: AscTec Trinity Control Unit System Warnings (Continued)
CATEGORY WARNING/
ERROR
MEANING CONSEQUENCE POSSIBLE
FIXES