Intermec PC4

Chapter 4 — ESim Commands
ESim for the PC4 and PF8 Printers Programmer’s Reference Manual 97
C - Cutter Enabled
If option C is enabled, cutting is performed after print. Commands JF
and JB are disabled but their values remain stored in memory.
If option C is disabled, no cutting is performed after printing.
Commands JF and JB are enabled. The f command is disabled but its
value remains stored in memory.
Example:
This example shows you how to enable DT mode, disable LTS, reverse
gap sensor, and the cutter. See the command below:
ON,D

oR - Character Substitution
Purpose: This command allows the advanced programmer to substitute the
Euro currency character (€) for any ASCII character in printer-resident
fonts 1-5. The original character can be restored by sending the oR
command.
Syntax:
oR[p
1
[,p
2
]]
Combinations of Various O Command Parameters
Command LTS (N )
DT/TTR
Mode (D)
Reverse
Gap (S)
Cutter (C)
O Enable TT mode Disable Disable
OD Enable DT mode Disable Disable
OS Enable TT mode Enable Disable
OD,S Enable DT mode Enable Disable
OS,Cnnn|b Disable TT mode Enable Enable
OD,S,Cnnn|
b
Disable DT mode Enable Enable
ON Disable TT mode Disable Disable
ON,D Disable DT mode Disable Disable
ON,D,S Disable DT mode Enable Disable
ON,Cnnn|b Disable TT mode Disable Enable
OCnnn|b Not used TT mode Disable Enable
OD,Cnnn|b Disabled DT mode Disable Enable