Intermec PC4

Chapter 4 — ESim Commands
110 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
Relative Reference Point Example
Example:
This example creates a 50 dot left margin and a 100 dot top margin
from the label edge set by q command.
r50,100 
S - Speed Select
Purpose: Use this command to select the print speed.
Syntax: Sp
1
.
S Command Parameter Descriptions
Parameter Description Notes
p
1
Speed select value:
0 = 30 mm/sec (1.2 in/
sec).
Available for 300 dpi
(11.81 dots/mm)
printheads only.
1 = 40 mm/sec (1.6 in/
sec).
Available for 300 dpi
(11.81 dots/mm)
printheads only.