Intermec PC4

Chapter 4 — ESim Commands
118 ESim for the PC4 and PF8 Printers Programmer’s Reference Manual
Example:
The example below shows a UDC command and a sample response.
UDC

004 
1-972698-02,Cardfirm 02 
1-972601-01,Base 4.01 
1-972699-01,Bootfirm 01 
1-972697-33,Intfont 01 
UE - Soft Font Information Inquiry
Purpose: Use this command to make the printer send information back to the
host on the soft fonts stored in memory.
Syntax: UE
Remarks: The printer sends the number of soft fonts and the name, height, and
direction of each soft font through the RS-232 or USB port.
The UE command is executed directly without appending a Linefeed.
Example:
UE

UF - Form Information Inquiry
Purpose: Use this command send information about forms currently stored in
the printer back to the host.
Syntax: UF
Remarks: The printer sends the number of forms stored and the name of each
form to the host through the RS-232 or USB port.
The UF command is executed directly without appending a Linefeed.
001-004 8 Cartridge detected. Followed by one to
four lines of information on detected
firmware, and/or Asian fonts.
Memory Cartridge Commands and Explanations (continued)
Command Explanation